Results 1 to 7 of 7

Thread: Handles

  1. #1
    Member benjamin_wooten's Avatar
    Join Date
    Jun 2010
    Location
    Halifax, NS, CANADA
    Posts
    14

    Handles

    I'm soliciting more opinions When it comes to crate handles . . . any preferred styles/brands that you all use?

    Thanks!

    BEN

  2. #2
    Chair of Publications Chris Barber's Avatar
    Join Date
    Feb 2010
    Location
    Boston, MA
    Posts
    122
    Hi Benjamin,

    Crate handles tend to be custom wood elements built right into the crate design. This allows for a stronger bond between handle & crate than would be possible with screw-mounted chest handles, as well as more positions for hands. Putting the tops of the handles at around 24" from the bottom of the crate might look a little low at first, but it's a good position for lifting.

    Cheers,
    Chris

  3. #3
    Member JasonO's Avatar
    Join Date
    Jun 2010
    Location
    St. Paul, Minnesota
    Posts
    172
    Look at Grainger for all kinds metal handles if you want them, here is an example:

    http://www.grainger.com/Grainger/items/1WAG1?Pid=search

    you'll have to look through stuff to find which size will handle the weight you have.

    J

  4. #4
    Member benjamin_wooten's Avatar
    Join Date
    Jun 2010
    Location
    Halifax, NS, CANADA
    Posts
    14
    Thanks both for your responses!

    BEN

  5. #5
    PACCIN Advisory Committee Member T. Ashley McGrew's Avatar
    Join Date
    Feb 2010
    Location
    San Francisco, CA
    Posts
    549
    I agree with Chris. My favorite type of handle is just the common wooden version that runs the width of the crate. As long as someone hits it with a round-over bit to knock off the corners and then make sure that they put in a few screws (I don't know how many times I have seen a handle pop off because someone just tacked it with a couple of of staples!) then it is hard to beat.

    The metal ones are ok on travel frames I guess but they are not very comfortable if the painting is heavy. The cushioned ones are better but boy are they pricey.

    Height is the most important thing with handles to me. Check with folks around you and measure the height from the floor to the palm of their hand while it is clenched in a fist and then subtract at least four inches so the crate can clear the instep while standing upright.
    Also remember with painting crates someone may be lifting one end so someone else can put a dolly underneath it. You don't want that person to be lifting a heavy crate up to shoulder height if you can help it so even lower than that may be better.

  6. #6
    Administrator Mark Wamaling's Avatar
    Join Date
    Jun 2010
    Location
    Washington, DC area
    Posts
    67
    Ashley makes some good points about wood handles that have been a standard. If the crate gets longer that 8 ft in length I like to run the wood handles along the length of the crate. This reinforces the lid and back and allows two or more people to lift from one end of the crate.

  7. #7
    Member
    Join Date
    Jan 2012
    Location
    Istanbul Turkey
    Posts
    5
    http://www.nielsenshop.com/index.php?_a=viewCat&catId=3
    You may find few kinds of handles by clicking this link.
    Regards

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •