Ashley,

Thanks for getting this on the Forum. I've just started working on another four mannequins for the exhibit we're currently working on and am always looking for suggestions.

As folks will see by the pictures I posted on my Flickr album, the Fosshape forms a hollow shell that is not truly rigid. from there a structure must be made and installed inside to support the actual weight of the garment and to give an interface for the support post. I've been carving a shoulder form out of dense Ethafoam, but the fitting of this is tricky and I haven't yet been satisfied with the conformity of my carved shoulder to the Fosshape shell. My real wish is for a pourable foam like basic two part urethane, but at least relatively archival. Any thoughts?

Thanks,
Jamie